Clamps
For holding round parts at one end or in the middle, allowing the probe around the part without interference.
Included: socket head cap screws. OD Min = 1.5 mm, OD Max = 64 mm, ID Min = 47 mm, ID Max = 64
| THD | HT | A | B | C | D | ADJ |
| M6/ M8/ ¼-20 |
127 mm/ 5 in |
178 mm/ 7 in |
56.3 mm/ 2.22 in |
70 mm/ 2.75 in |
19 mm/ 0.75 in |
1.5 mm– 64.5 mm |
Hold and secure cylindrical/tubular parts at a specific angle. Available with six different female/male removable centering pin options for different length parts allowing for maximum access.
| THD | ADJ HT | WDTH | DPTH | ADJ L | MAX DIA |
| M4/ ¼-20 |
0-30° | 155 mm/ 6.13 in |
50 mm/ 2 in |
73 mm/ 2.89 in |
29 mm/ 1.14 in |
For holding cylindrical parts at each end on their inside diameters.
Included: both male and female centering options; socket head cap screws.
Non-marking clamp for securing 13 mm and 19 mm thick plates to a CMM. Includes screws for M8, M10 and M12 inserts.
Note: Included: screws for M8, M10 and M12 inserts. Set of 2
| THD | HT | A | B | C | D | E |
| M8/M10/ M12 | 34 mm | 193 mm | 32 mm | 90 mm | 18.3 mm | 11.9 mm |
For more clamping force. Included: socket head cap screws and washers.
Has adjustability to hold cylindrical parts up to 26 mm in length and 25.5 mm in diameter.
Includes socket head cap screws and washers.
| THD | A | B | C | ADJ |
| M4 | 50.8 mm | 31.8 mm | 12.7 mm | 26 mm |
For securing small and delicate parts using a spring pointed Delrin® tip, with minimum force and contact.
Includes socket head cap screws and washers.
| THD | HT | A | B | ADJ |
| M4 | 29 mm | 103 mm | 19 mm | 25 mm |
The clamp has an adjustable spring arm for different diameter parts and also an adjustable end stop (two interchangeable feet are included).
| THD | HT | A | B | ADJ |
| M4 | 48.5 mm | 75 mm | 12.4 mm | 0-24° |
Ideal for holding parts horizontally or vertically. Jaws have a V notch for holding cylindrical and tubular parts.
Included: socket head cap screws and washers.
For clamping a small area of a part. Vise can be rotated 360° and then locked into position.
This tension clamp contains an adjustable rubbertipped plunger to reach over the edge of a part and apply a clamping force inside a recess.
To push a part against standoffs or into corner (two interchangeable tips are included).
Included: socket head cap screw, thumb screw and washer.