Adjustables

Showing all 12 results

Active filters
Clear Filters

To place components in between holes on the plate.
Included: socket head cap and thumb screws.

Ideal for holding components on an angle. The angle plate is adjustable to 180°.
Included: socket head cap screws and washers.

To allow variable heights without marring the part.

To allow variable heights of up to 22 mm and then lock into position.

For cylindrical parts smaller than 6.5 mm in diameter.
Note: Included: socket head cap screws.

THD HT A B C
M4 8 mm 25.4 mm 23.8 mm 10 mm

For positioning a component at any angle. Lock the rotating base into position and then set the angle of the pivot.

To place components in between holes on the plate.
Included: socket head cap and thumb screws.

Screw any component onto the acrylic slide to extend the reach of the component.
Included: socket head screws.

THD HT A B C ADJ
M4 10 mm 82.3 mm 12.7 mm 25.4 mm 186°

To aid viewing and inspecting a part.

For holding cylindrical or tubular parts without marring the part’s surface. Can be rotated and locked to any orientation.
Included: shoulder bolt.

Threaded slide plate, designed to mount fixturing components to, using the QuickLoad Corner (QLC).
Included: socket head cap screws and washers.

For holding small cylindrical or tubular parts with minimal surface contact.