Fixtures

Showing 1–12 of 93 results

Active filters
Clear Filters

The 1/4-20 CMM and Equator system clamping component set can be used to hold aluminum, plastic, brass, titanium and other nonferrous parts.
To build your kit, select an appropriately sized base plate for your requirements with 1/4-20 threaded holes. Don’t forget to ask your sales representative to add on plate clamps or mounting holes to your order to secure your plate to the CMM granite.

The 1/4-20 CMM and Equator system magnetic and clamping component set can be used to hold steel, aluminum, plastic, ferrous and other non-ferrous parts.
To build your kit, select an appropriately sized base plate for your requirements with 1/4-20 threaded holes. Don’t forget to ask your sales representative to add on plate clamps or mounting holes to your order to secure your plate to the CMM granite.

To elevate and locate a part. Available to order in M4, M6, M8, M12 and 1/4-20 thread sizes.

The ¼-20 vision component set can be used to hold any type of part, ferrous or non-ferrous.
N.B.: Ensure that the acrylic plate and QuickLoad corner you select will fit your specific machine. Please contact your local sales representative to discuss your requirements.

For locating within a hole or slot of a part.

For holding round parts at one end or in the middle, allowing the probe around the part without interference.
Included: socket head cap screws. OD Min = 1.5 mm, OD Max = 64 mm, ID Min = 47 mm, ID Max = 64

THD HT A B C D ADJ
M6/ M8/
¼-20
127 mm/
5 in
178 mm/
7 in
56.3 mm/
2.22 in
70 mm/
2.75 in
19 mm/
0.75 in
1.5 mm–
64.5 mm

For locating within a hole or slot of a part.

To place components in between holes on the plate.
Included: socket head cap and thumb screws.

Ideal for holding components on an angle. The angle plate is adjustable to 180°.
Included: socket head cap screws and washers.

Hold and secure cylindrical/tubular parts at a specific angle. Available with six different female/male removable centering pin options for different length parts allowing for maximum access.

THD ADJ HT WDTH DPTH ADJ L MAX DIA
M4/
¼-20
0-30° 155 mm/
6.13 in
50 mm/
2 in
73 mm/
2.89 in
29 mm/
1.14 in

To allow variable heights without marring the part.

To allow variable heights of up to 22 mm and then lock into position.