Motorized Probe Heads Accessories

Showing all 12 results

Active filters
Clear Filters

The AM1 adjustment module is designed for use with the PH10T and PH10M probe heads. Each module provides quick and accurate angular alignment of the motorized probe head with the CMM’s axes and/or the autochange rack. The quick release mechanism allows the head to be removed for storage and replaced without further alignment.

Size 60 mm x 15.5 mm
Adjustment ±2° in pitch and roll*
±4.5° in yaw
Overtravel ±3.5° in pitch and roll
Mounting Mounts to quill using shank
*Up to ±5.5° in pitch and roll is possible, but at the expense of overtravel.

The AM2 is designed for the PH10MQ probe heads. Each module provides quick and accurate angular alignment of the motorized probe head with the CMM’s axes and/or the autochange rack. The quick release mechanism allows the head to be removed for storage and replaced without further alignment.

Size 80 mm x 10 mm
Adjustment ±1° in pitch and roll*
±1° in yaw
Overtravel 0
Mounting Mounts direct to quill

*Up to ±5.5° in pitch and roll is possible, but at the expense of overtravel.

The HCU2 hand control unit enables the probe head to be used in a manual mode or during a teach cycle. An LCD dot matrix display provides information and status of the PHC10-3 system.

  • Basic low cost joystick for 3-axis CMM without an LCD
  • Compatible with the range of Renishaw CMM controllers and incorporates all the functionality of the HCU2 hand controller for motorised head
  • Basic low cost joystick for 3-axis CMM without an LCD
  • Controls motion of CMM axes
  • Indexes the motorised head and rotary table
  • Has a system menu for navigating the operating software
  • Handheld or table mounted operation
  • The wireless manual control unit (MCU W-2) is a comprehensive joystick designed for use with Renishaw’s range of UCC controllers
  • Based on the MCU5-2 joystick design, the MCU W-2 uses modern battery technology and Bluetooth® radio modules to provide an effective wireless joystick with a maximum of 25 m range and over eight hours between battery changes
  • A spare battery and an automatic charger are included in the joystick docking cradle
  • The manual control unit is a comprehensive CMM joystick controller designed for use with Renishaw’s range of UCC controllers
  • It includes the functionality of both the Renishaw standard UCC joystick interface and Renishaw PHC10 hand control unit (HCU2)
  • The MCU5-2 is a development of the MCU5 joystick, with new buttons and new functionality
  • The MCU5-2 has been developed for use with Renishaw’s REVO system and PH20, providing the ability to move the CMM in the axis of the probe and stylus

The PHC10-3 PLUS head control receives instructions and processes signals to rotate the angles of the PH10 PLUS series probe heads. The PHC10-3 PLUS is compatible with all PH10 PLUS heads. It has its own internal power supply.

Data transmission RS232 or USB
Input connectors 15 way ‘D’ Probe
Output connectors 7 pin DIN or 9 pin D type
Maximum cable length 50 m (164 ft)
Hand control HCU1 (purchased separately)

This variant of the PHC10-3 PLUS controller includes a prefitted PI200-3 interface card in a single 1U case.

5 meter cable for MCU.

10 meter cable for MCU.

20 meter cable for MCU.