Renishaw

Showing 1–12 of 1386 results

Active filters
Clear Filters

Faro 1 ¼–20″ UN, Ø6 mm zirconia ball

Faro styli are specially designed for use with Faro arms. Zirconia is a particularly tough ceramic material with hardness and wear characteristics approaching those of ruby. Its surface properties make it an ideal material for aggressive scanning applications on cast iron components.

Equivalent to Q-Mark part number: QMFP-6-Z

Ball dia. mm (in.) 6
Length mm (in.) 57

 

Thread M1.25-20 UN
Ball dia 6 mm
Stem material Tungsten carbide
Tip material Zirconia
Holder material Stainless steel
Centre styli N

1 ¼–20 cone pointer stylus for Faro arms with 30° angle, L 75 mm

Faro styli are specially designed for use with Faro arms. Zirconia is a particularly tough ceramic material with hardness and wear characteristics approaching those of ruby. Its surface properties make it an ideal material for aggressive scanning applications on cast iron components.

Equivalent to Q-Mark part number: QMFP-S30-C

Ball dia. mm (in.) N/A
Length mm (in.) 57

 

Stem material Stainless steel
Thread M1.25-20 UN
Tip material Tungsten carbide

The 1/4-20 CMM and Equator system clamping component set can be used to hold aluminum, plastic, brass, titanium and other nonferrous parts.
To build your kit, select an appropriately sized base plate for your requirements with 1/4-20 threaded holes. Don’t forget to ask your sales representative to add on plate clamps or mounting holes to your order to secure your plate to the CMM granite.

The 1/4-20 CMM and Equator system magnetic and clamping component set can be used to hold steel, aluminum, plastic, ferrous and other non-ferrous parts.
To build your kit, select an appropriately sized base plate for your requirements with 1/4-20 threaded holes. Don’t forget to ask your sales representative to add on plate clamps or mounting holes to your order to secure your plate to the CMM granite.

To elevate and locate a part. Available to order in M4, M6, M8, M12 and 1/4-20 thread sizes.

The ¼-20 vision component set can be used to hold any type of part, ferrous or non-ferrous.
N.B.: Ensure that the acrylic plate and QuickLoad corner you select will fit your specific machine. Please contact your local sales representative to discuss your requirements.

For locating within a hole or slot of a part.

2x M1.4 Adaptor 20°

D3 MTG 2x M1.4 Adaptor
Mass Grams 9.73

For holding round parts at one end or in the middle, allowing the probe around the part without interference.
Included: socket head cap screws. OD Min = 1.5 mm, OD Max = 64 mm, ID Min = 47 mm, ID Max = 64

THD HT A B C D ADJ
M6/ M8/
¼-20
127 mm/
5 in
178 mm/
7 in
56.3 mm/
2.22 in
70 mm/
2.75 in
19 mm/
0.75 in
1.5 mm–
64.5 mm

For locating within a hole or slot of a part.

Data transmission: Serial (RS232)
User-definable parameters: Baud rate 300–19200
Voltage range: 85 V–135 V, 170 V–275 V, 50/60 Hz automatic selection
Height 88 mm (3.46 in)
Width: 289.30 mm (11.40 in) – 2/3 of a 19″ rack
Depth 220 mm (8.66 in)
Weight: